So Sawdustdad, It looks like your teaser spring resides almost completely inside the spring spacer “cup”, yes? If this were the case, move #4 in between #20 and #5, this would allow the throw out bearing and the release arm to move forward on the shaft. Then the bottom of the release arm would pivot further forward, as driven by the throw out bearing and the blue spring, thus eliminating the need for the spacer that I added between nut #12 and the release arm. But, if I turn the TB around, I would loose those gains and then have to add the spacer back in????? Forgive my ignorance on these matters gentlemen, but it all seems contrary to the schematic. Maybe I’m to stupid to realize that the schematic is wrong, maybe???
|