Quote:
Originally Posted by Matt G.
As long as the rear of the driveshaft is seated properly, just unbolt the engine, slide it forward, and then slide it back, and make sure the driveshaft winds up inside the spherical ball bushing instead of jammed up against it.
|
When I installed the engine I:
1. Mounted it to the modified cradle
2. Tipped the engine in, and 'aligned' the drive shaft
3. Put in the rag joint and finger tightened the bolts
4. Installed ISO mounts and finger tightened them
5. Went around and tigtened all of the ISO mounts to the frame
6. Tightened up front and rear rag joint bolts
Are you saying that I should have installed the cradle and then put in the engine?
How do I gurantee that the holes will line up?