So far, our fix up restoration is goin' fine.
Grandsons 'n I are going to look at a frame and dozer (snow) plow tomorrow. The boys are excited, seat time and no school.
We'll be stoppin' at TSC for paint and a walk-about, boys'll be boys ya know!
Now the hydraulic lift is working but, just a couple of questions. When down, max low, the two pins for the frame attachment are just 'bout even with the frame (top of pin at low max on the frame, visible).
The indicator moves to "1" (low). High max reads "7".
Is the lift moving to the lowest, where it should be? Or, should the pins be lower?
