Quote:
Originally Posted by yeeter
I have the axle seals and gaskets and the rear cover gasket - any need to change the needle bearings while there? (I was thinking not).
|
I would.
Quote:
Originally Posted by yeeter
Should I just do both trunions while into this far? I think may as well, even if a little more time. Which means breaking the hydro so need that seal. (have the hydro to rear end seal).
|
I wouldn't. I don't open a hydro unless absolutely necessary. The seal on the drive side never leaks anyway. You'll put 3 in on the right side and still may never change the left.
Quote:
Originally Posted by yeeter
Will also add a top plate gasket to the list.
|
Silicone
Quote:
Originally Posted by yeeter
What did I miss? (anyone already put together a cheat sheet for a rear end build? If not, maybe its time I pulled it together with part numbers and cross references)
|
What numbers do you need? I have all the seals for the hydro handy (input, output, trunion) in NAPA numbers.
