Quote:
Originally Posted by R Bedell
The 1250's original wiring would have had a Molex Plug on the end of the wires going to the Ignition Switch. One would have had to simply unplug the connector, replace the switch with the correct on and plug the harness back in.
Are you saying that the Molex Plug Connector is not there....????
Next, if you have the correct switch, then wire the switch to the diagram listed in our Technical Library Section.
I suspect the wires are the correct color, but after 30+ years, the color has faded. That is assuming the harness is original.
 |
Ah Ok that is very helpful. After digging into it I see wires spliced together every where. No plug and play here,
no Molex connector to be found. Not sure what someone was attempting. I asked previous owner if he ever had a switch and he said he always started it by jumping wires with screw driver. Im already bald so no worry of pulling out my hair. I suppose its time to start rewiring it from a fresh start.
Thanks for your helpful insight