Quote:
Originally Posted by R Bedell
You need to pull the Drive Shaft out. Replace any worn drive line parts (couplers, adapters, flec discs, bushings, etc) plus the fan.
Once the drive shaft is out, remove the Hydro Unit input shaft Adapters (pound out the spirol pin). Once removed, pull out the defective input shaft seal. Take that seal to your local Auto Parts store for cross reference, and obtain same. Install new seal.
Once you have all the drive line parts as needed, re-assemble the drive and install back into tractor.
Check you Hydraulic Fluid level and add if necessary.
Wha-La.......you are good to go.
|
Well, the pin came out easy but the seal, that required a little more surgery. New seal went right on and in. Just going to make a new driveshaft, get a new fan and new rubber connecting disc?? Where do I get a new one of those. I didn't see one on patton acres. Also, should I turn a little concave radius on the end of the driveshaft that meets the coupler for the ball bearing to ride on? There is a wear mark on the current one. Last questions, what diameter is that ball supposed to be? It can almost slide right through the coupler. My guess is the coupler has wore not the bearing. I attached two pics