View Single Post
  #5  
Old 09-15-2014, 11:58 PM
skeer skeer is offline
Member
 
Join Date: Sep 2014
Location: MI
Posts: 79
Default

I downloaded the angle kit install guide and the plow manual/guide. I am missing that silver part on one valve. But as it sits right now I have the deck lift valve on the tractor, and then these three on my bench.

I also have 4 bolts that are long enough to bolt together three valves.

Can these valve go bad or break internally as to not work?

Tonight I fully disassembled the angle kit, the bolt that hold the left/right angle cylinder shaft was bent almost an inch. Looking it was the original grade 8 bolt too. Silly question but should I be able to depress the shaft into one of the cylinders with it off and unhooked?
Reply With Quote