Quote:
Originally Posted by EarlJ
Yes çat 0 I saw a setup built allowing the use of the Brinley set up still. His lift arms look to be too long. It's a pretty neat set up because it uses the upper portion of the rear lift via the pin hole.
|
I saw that on facebook too. Cool idea, but I think it needs some tweaking. For one when finished it was sitting on the ground. I can tell by looking at it that it's not going to lift high enough to do anything. I think his arms look really long because on a normal cat 0 the arms go under the tractor a little bit, where his only go the back of the rear end. I think he was onto a good idea, but all the kinks are not worked out yet. I'll go out it a minute and measure my lower arms if nobody beats me to it.