If there was an exact fit aftermarket, we would know about it. There isn't. Close seconds...... but not
exact replicas.
Here's what you do:
Take a look at the mounts that the angle package uses.
Take a rough guess at where that point would be on the blade frame, and moldboard.
Angle the blade all the way one way and take a measurement.
Angle the blade all the way the other way and take a measurement.
This will give you a pretty good idea how long of a stroke you need. The cylinder size is not really that important. At least 1.5" bore would be fine. Once you get a cylinder, fab the mounts and location to fit that cylinder. Easy peezy.
A QL cylinder is very close to the same cylinder as the angle cylinder.
A power steering cylinder (cub cadet/john deere) is very close to the same cylinder as the angle cylinder.
Oh, and check this out:
http://www.onlycubcadets.net/forum/s...ad.php?t=32544