Quote:
Originally Posted by Alvy
Great job. Where and what brand of bore micrometer is that? I'm looking to get one. Your sister will have quite the tractor when you're done. Sweet
|
It's an inexpensive Shars. It's a little funky to setup, it uses different sized rods and spacers. Pretty much you make it a hair over what the bore is, measure it with a mic to get your starting point, measure the bore then do the math.
I've used the type to you can adjust to any size in the past, those are really nice but a lot more money. I had the machine shop verify my measurements and were were the same so I'm happy with it.
K