[lwrehm]

With the help of the recent thread on removing the driveshaft pin to remove my drive shaft. I did find out why it was so hard to remove, there is a bit of a divot on one side.

So I'm getting ready to make my parts list, and in looking at the diagram they don't show washers, but they are listed in the parts list. Who ever put it together last did put washers at each end of the spring but the one on the clutch end was all torn up and wedged between the spring and the drive shaft wearing a nice groove in the shaft, I have a salvage one to replace that. I also need a thrust bearing and a teaser spring for sure (old one is broke in two).