[rebel715]

I ordered new engine mounts and have "attempted" to install them. I have the engine bolts out and the old motor mounts out as well. I am having a problem separating the engine from the driveline. What procedure do you do to do this? I could not find it in the shop repair manual. All 4 of my bottom engine mounts were trashed, so I am presuming the other problem I am seeing is a clutch plate with a lot of chips from the outer edge. I would like to remove the engine from the driveline to replace the clutch disk and don't know how. It looks like a roll pin in the driveline on the front and back side of the clutch disk on each side of the plates. Do I drive these through with a punch? Thanks.