Quote:
Originally Posted by Buurgy
Hi, Burgy Here..
It's my unit, I pulled the urethane bushings out this morning. puting the old ones back in using the best ones in the rear and bottom.
The vibration is all but gone, will get new mounts when it starts acting up again.
The next issue is the fuel tank/plastic/ PO must have cracked it and tried to fix with not so good stuff. Guess I will have to find another one.
Thanks
|
You should have used a rubber mount close to the same duro as the factory mounts. Of course, factory replacement are the best choice. I have aftermarket-modified, and have no trouble since. The real bugger is the new flex couplings I installed on my 1450. They seem to need to have a certain amount of break-in time. The old flex coupling I removed produced little vibration compared to the new.
Hood hinge- remove and repair/tighten up in a vice. Install new hood bumpers too. I can go on and on,.............