Instead of starting a new thread, I'll add my problem to this thread.
On my 125 with hydraulic lift ( other is a 125 with man lift ), I just replaced the homemade wiring harness with one I purchased from mlamar. All wires were marked and installed as tagged. I did bypass the safety switch ( jumper ) since it's broken and was bypassed with the other harness
The ignition wires were a plug and I pushed the plug into place. The switch has 5 prongs on it.
It starts but shuts off as soon as the key is released. If you turn the key back to start, it runs again.
Any ideas on what to check?
Thanks
Jeff
|