149 only runs with key in start position
Hello,
So my 149 restoration project continues...I've replaced the alternator, the starter, the solenoid, the wiring harness, muffler, head gasket, etc. Here's the issue. I finally get the engine to turn over and start yesterday by shorting out the PTO and clutch pedal safety switches. But the engine will only start and stay running while I'm turning the key to the start position. As soon as I release the key the engine stops. I've checked the wiring diagram for the 149 several times and everything seems to be wired and connected properly. What is going on/what have I done wrong? If I switched wires to the large posts on the solenoid, could that be the problem? ANY help would b greatly appreciated, I'm going broke buying new parts and getting really frustrated. Just want to cut the grass and get this beast up and running. Thanks for any help. Matthew+
|