Quote:
Originally Posted by Yosemite Sam
I think what you are wanting to know is: The point on the set screw is just past the back edge of the bearing. As the set screws are tightened it literally pulls the pto onto the bearing. The front of the bearing bottoms out on the back of the snap ring inside the pulley.
|
Yup, just like the picture shows.
__________________
Daniel G.
.
(May 1970) 147 w/an IH spring assist, 48" deck, 42" blade, 1969 73, #2 trailer, 10" Brinly plow and (on loan) Dad's #2 tiller.
|