Guys
After talking to a couple bearing reps, the bearings that came in the factory Cub pulleys are NLA. What I'm thinking about doing is to make the pulley slightly thicker so that we can run the same bearing that all the other mule drive pulleys use. Shouldn't make much difference. What do you guys think? I'll need to order at least 6 so if I get commitments for the 6 I'll proceed.
__________________
2264 with 54 GT deck
1641 AKA Black Jack with a 402-E Haban Sickle bar mower
JD317 dump truck
BX2670 with FEL
|