[AL Farmall Boy]

New-to-me tractor of this type.....After changing the alternator belt, I noticed there was a brass (or bronze) bushing that almost fell out while trying to re-install the driveshaft to the engine. Without much luck from a Cub Cadet dealer or the internet parts diagrams; I decided to remove the entire driveshaft to get a closer look and so I could take some pictures to hopefully get some help on the forum. In these pictures you can see the worn out bushing and where it fits. It fits inside that round rubber type disk.....that is where it fell out of at least. I am thinking that the bushing is part of that rubber disk housing as 1 unit, but I am not sure about that. What do you all think? Also, notice the fins on the plastic fan; they are buggered up a little....will that be ok to leave as-is? I need to get the parts ordered so I can get the 1772 back up and running.

Thanks for any input you can give