On the way home yesterday I stopped by the case dealer and picked up a belt for my tiller..... Different guy than before so of course he said I needed a different size belt. I picked up one thats 143.8 inches accoding to the thats supposed to be the one I need, and it was the only size they had in stock, I figure I'd give it a try, might get to that tomorrow morning.
Last night I took off the snow blade, pulled off the cover from the rear to change out and put Hytran in it and started working on getting the tiller mounted. After getting the cover off and cleaning the old gasket while the fluid drained I tried to change the filter and realized I didn't have a filter wrench, let someone borrow it. So I took measurements on some other parts I needed. Then I cleaned up, went to Home Depot and picked up some all thread and steel so I can make a belt tensioner for the muler drive and get rid of the spring, Had to get 1" bolts to bolt the gear box on to the rear, and picked up a Clevis, and some quick links to use from my lift pin to the chains on the tiller since I do not have the adjuster T and rod and my pin has a horizontal hole in it.
I'm working all day today then as soon as I get home I have to go to the other job so I won't get to work on it again until Saturday
