[sixty8cat]

I have long wanted to install a creeper in my 102, so I found a 104 with a creeper. I swapped the 104 creeper, drive shaft, clutch into the 102. When I was done, fired the engine, left the clutch out and nothing..it won't move. It appears as if the clutches are slipping, when in fact both worked well before I swapped everything over. The 102 clutch, drive shaft, works fine in the 104. I did install a new throw out bearing and teaser spring on the creeper shaft. Could the teaser spring not be stiff enough? I split the 102 again and tested the creeper on the ground. It spins over fine when using a drift pin to spin the input shaft. I am lost. Do I need new clutches?