Just as I finished plowing our 125-yard lane, my plow lift lever stopped working and flopped down.
I used CJet's photos to figure out how to get to it (eternal thanks for the great photos), but found that my stainless steel roll pin was fine - it was the shaft that snapped! - right at the hole that fits the roll pin.
BTW - Mine had a hollow, stainless steel roll pin - not a solid shearable pin like CJet found in his.
I've got bar stock, a drill press and a rod bender, so I'll fabricate a new handle & rod tomorrow, then see if I can get it back together again in time for the next snowfall...
- Al
1250 for the lawn, 1450 for the snow... (& for pushing brush piles around)
