K 181 governor
Got the chance to work on the 70 today to see how well I had done I had just put the carb on after a good overhaul on it and decarboned and lapped the valves checking everything out to see if we needed a overhaul or not...The valves looked pretty good but the guides are a little worn but not out of speck.Anyway after the I got her fired up and running for 15 minutes or so I started adjusting on the carb to fine tune her when I noticed quite a bit of oil seeping around the governor area and running down the block. Looked like around the where the shaft came out of the block.I looked up the parts diagram on the thing and I cant tell if theres a seal there or not.So there lies the question Is there a seal there and how hard it is to change if so. Does it seal from the inside or outside? Thanks Randy
|