Well a few more hours in than i thought but i got what i wanted from it, the PO did a great job on discharge channel but i wanted a it a little better so i spent some time in the two front corners and replaced left panel while i was in it (the white primer) pained it up with some black enamel, used some 1/8" flat stock i had in the corner and used a empty metal cylinder about the size fo a pail to get my bends, did about half the fitting with cut off wheel on angle grinder and got my hands on a sweet little plasma cutter, a couple of clamps, mig welder and fine adjustment tool (hammer) got the job done. Also i made a middle support out of channel, seemed like it wanted something there more to follow
__________________
|