[Cubcrazy]

Originally Posted by dsmith

I have been lurking on the site for about a month now. I would like to thank everyone involved for this great site.

I have a 1979 1650 with 3 point lift, front hydraulics, 50"deck and blade that I purchased about 2 years ago. I have recently done the craddle mod, installed new points/condenser and plug/wire.

The leading/forward edge of the teeth on my flywheel are worn. It surprisingly sounds fine but I would like to get a spare to keep in the shop just in case.

Does a flywheel from a 1250 and 1450 fit on a 1650?