this thread is a little old but i am rebuilding a k341 that i broke the rod in lots of pieces, cause the oil ran low. i made steal plug that goes where the crank goes in the id with a large handle i can tap on. thay came out nice. when rolling them i felt some things that may have been contaminates on teh races or balls. i dont know what all got in there from teh grenade or sludgy oil. well im looking at bearings now too. mine was an SKF 6308/C3Q66. when i looked it up there was nothing on SKF's site with those numbers. there was about 6 different 6308 bearings on there though with different specs. Brian Miller has aftermarket ones on his site for $15 each from china. id rather not have a china bearing in there. so do i just look for a bearing that has just 6308?
__________________
1979 1650, #1 tiller with one extension, 90 degree box mounted, 3 point. 1961 4 digit bringing back to life. I have the mower and 3 pint for it. The 1650 is the fastest mower in the neighborhood.
|