Adding some pics.
The first one shows what it is like now. Throttle connected direct to carb, governor lever arm disconnected. You can see the 2 mounting holes in block for the governor assembly. Throttle cable comes in from left (right side of tractor)
I have the linkage below (#222). What I need help with is knowing what to connect to what.
How to connect throttle to governor assembly, which place exactly.
How to connect governor arm to governor assembly
How to connect carb up
Where do springs go
I think the pin that can be seen in the governor lever arm rides in the curved channel of the assembly.
I do have the linkage, item 216 but not sure where it goes.
The other problem is when this engine was installed, the exhaust apparently was from another unit and it gets in the way of the governor assembly. The previous owner tried modifying the governor assembly by cutting off part of the bottom. I think he may have given up, because it was not installed.
Any help or photos appreciated! I did get the motor running but worried about running it without governor connected up.