Quote:
Originally Posted by vartz04
Any chance you coulda gotten by with 1/4". I can't pull off 3/8 with my welder but I've done 1/4 before without any major failures just a lot of beveling I'd appreciate the pics when you do take it apart.
|
Vartz
Took the winch mount off and got some pics for you. As I said the base is 6.5” wide and 6” high. It’s 3/8” plate drilled and tapped for 3/8” bolts to attach the winch. It just pins on at the same place that the factory lift would.
I also flipped the winch around for a better angle on the cable while I was at it.