[bignastyGS]

Worked on my sons 149 and had to replace the valve that feeds the hydraulic lift cylinder. After that it still wont pick up the plow. I discovered the rockshaft roll pin on the outside of the frame(the bracket the lift lever for the snow plow hooks to). So I pulled the ends of the roll pin on each end off with pliers. I ended up removing the rear fender and seat to get better access,but now I have beat mercilessly on the broken roll pin.I started with a small punch and tried going up in size from there but that pin doesn't move or want to attempt to move. Can I heat it and try to remove it? What size drill could I use to try that if all else fails? I really don't want to remove the shaft if necessary so that will be my last option..What size roll pin should I get as well??