[teejk]

I feel bad for opening a new thread but I had to give up searching old posts.

I want to replace the 38 year old valves on the hydro pump. It has leaked somewhat from when I bought it 32 years ago but it is getting worse plus the reverse is getting more and more "iffy" and I figure it's time.

The cover from the steering console to the seat would probably grant access to the valves but as long as I'm at it, would be a good time to pull the rear clip and do a proper clean-up. It's filthy.

Before I start though...

It looks like battery comes out, 4 bolts in the rear battery pan. Moving to the front, 4 bolts on each side that look like are simple hold-downs for the diamond plate foot pads (philips type on top but a hex nut on the bottom). I assume they also secure the clip, if not I'm screwed since everything else appears to be welded to the frame.

If I'm correct, are there any other bolts holding it that I haven't found yet?