Hey Thanks Guys, here's a few more pics, I hope you can make heads or tails out of it, hard place to get good pics. I put the hydro control shaft right in front of the brake cross shaft. The shaft for the hydro is out of the 680 just cut the handle off it, and grind a notch in it and added an inch or so where the linkage bolts on, used channel iron for the brake pedal to clear the tension nut and shaft for the hydro, all the linkage rods are from the 1650, brake linkage I used a turnbuckle (I cheated
) The linkage that pulls it into neutral when the brake is pushed is about all I have to fine tune yet. If I get this finished before the snow lands here my 149 and 126 won't get to play it.