Ok. I adjusted the steering and the Hydro as best I could. The drag link is bottomed out on both sides and I still have about 1/2 inch of lost travel, but to the left this time. Should I try adjusting the tie rod now?
The Hydro is better...I noticed the damper spring plate wobbles back and forth a lot. So much so, that in one direction the tractor wants to move in Neutral and in the other, if I hold it there with my hand, it seems fine. The outer compression spring seems very loose and as if it is not giving any pressure on the pin spring guides. It appears that if the compression springs were tighter, the damper plate may not rock from side to side. Just a thought.
Suggestions?
Yesterday I picked up a Sears moldboard plow in great condition. Looking forward to hooking it up and tearing up some dirt. Tomorrow (today) I'm headed North 3 hours to PA to pick up the CC wheels I found and my new-used hood is on the way.
Thanks again guys for all your wisdom.