Quote:
Originally Posted by mickb72
Hi all, i have a mag 18 spec# 24585. Where can i punch in that # to find crankshaft dim. I haven't had much luck on kohlers site. I pulled the bolt from the electric clutch on front and it looks to be 1"? I would like to know dia.x length for sure and what it was spec. for. I want to put this in a 582 and use that elec.pto, or if it is 1" would the elec. pto off the briggs work on the mag 18? Thanks for any help. Mike
|
If its 1" shaft and you have a clutch with a 1.125" bore it's an easy fix. You just get a 1" ID X 1.125" OD bushing and some 1/4"X 5/16" key stock. McMaster Carr
http://www.mcmaster.com part number 6381K18 for the bushing and 98491A137 for the key stock. Just did it on a tractor I was working on. Had to run a brake cylinder hone through the bore because it was a little on the tight side and also had to run some emery paper over the outside because it was also a little tight for the clutch bore. Then you just cut it to length and cut a slot for the keyway.
