[mrcubcadet]

I am in the middle of putting a 16 HP in a 1200, as some of you might know from my thread. Decided to try to make the engine a direct-mount, and got talking to Adam (IHinIN) and he thinks he can make steel bushings to replace the rubber mounts. But, we will need dimensions...such as diameter, and length to make the steel bushings. Length at least..to get the drive line right. (Height when sitting in frame in operation position)



And on the top bushings, we probably could just use washers..Since there will not be any need for suspension, but to keep the mounts held down.