OK thanks...that's a big help. So, the bearing is not attached to the collar, but is keyed and just a press fit. I didn't want to pull on it much since I wasn't sure if the collar and sets screws were involved in holding the bearing on.
So... get the bearing off with a puller (and PBblaster and words)
The unthread the collar, then remove the basket pulley.
Sounds close?
Thanks VERY much
John
__________________
61 and 63 Originals
123 (2)
782D
106,
147, 122
102 parts
It's only original ONCE!
|