View Single Post
  #1  
Old 04-23-2012, 05:57 PM
jbrewer's Avatar
jbrewer jbrewer is offline
Grand Member
 
Join Date: Sep 2011
Location: NC
Posts: 2,597
Default PTO bearing collar question (pic)

I've got a 241 on the bench, and I want to check it out and R&R as required. I got one set screw out of each of the holes that I've circled in red rectangles in the photo below. They took a lot of PB and time, but they came out.

There's two other holes , one on each "step" of the collar , one of which is show in the red oval. This hole doesn't SEEM to contain a set screw, it almost looks like it's started to have been drilled....there's no hex to be seen.

My question is that (if you use the terminology in the 2nd photo) is are there two set screws in each set screw hole in the INNER and OUTER collars

or

two sets of holes in each INNER and OUTER collars, each with one set screw ?



THANKS and sorry if this is cryptic..I've tried several times to word it better.

John
Attached Images
File Type: jpg COLLAR.jpg (48.1 KB, 119 views)
File Type: jpg COLLARPOST2.jpg (22.9 KB, 119 views)
__________________
61 and 63 Originals
123 (2)
782D
106,
147, 122
102
parts

It's only original ONCE!
Reply With Quote