Quote:
Originally Posted by Methos
Ok, here's the update.
I hae everything I need to make the hydraulic pump fit on the original! Once you have the pulley your set with some mods. You can make the pulley using other cub pulleys! The brace from the dash tower to the hydraulic pump is to long but can be cut to fit. The lifting bracket that the ram attaches too is off an 100 so that will work with no mods! The NF hydraulic manual shows the lift handle mod and where to drill into the frame for the mounting plate. You will need to use the 3 frame spacers.
Once I get into this weekend I'll do a write up and make a PDF if there is enough interest.
Yes I'll have pics with it!
|
That is way too much modification for ME to make!!
And again, we can't wait to see the pics!!!
