When progress stopped
Last time I worked on this engine, as I recall, one of the grease/oil seals on the crankshaft went on what I thought was loose feeling.
Its on the flywheel end of the crank. I believe it slid on with just pushing with a couple screwdrivers down into the groove for it.
I don't think its the right seal. I need to take that off and get that fixed before going any further. No need to put it back together and have to take it apart again. Its a seal that came with the overhaul kit. Could be I used the wrong one, but there were only two that looked alike.
Dave
|