International #48 tiller
 

I need some help from you good people , I have a 982 & recently acquired a #48 International tiller for it. My issue is that in a previous life someone has changed to PTO shaft to use it on a diff tractor . I have a new male yoke which locks into the PTO coupler on the tractor but thats all Ive got . If any of you have an original shaft , could you please send pics & length measurements of BOTH halves of the shaft , so that I can build an original design shaft . I can source most of all of the parts through Weasler but Id rather not have to use the non original shaft {which came with the tiller} as a guide. Any help would be greatly appreciated I also realize that this tiller was likely modified for diff PTO speed, but thats easy to do via new sprockets . While Im asking , what is the original tine shaft speed when used on an org Cub 982 with the 2000 rpm PTO Thanks in advance

I sold a Snapper tiller a few years ago that is the same as the IH one. Are you looking for the rear half that attaches to the tiller? If so, I can get some picks and measurements today for you.
Here is the Snapper shaft. It was sold with the tiller.
Attachment 116565

This is my tiller I still have and can get you the measurements you need. It is a Cub Cadet model #193-356-100 if you need to do any parts look up info.
Attachment 116566

Oak, where'd you get that model number?
The parts lookup site doesn't recognize it

Same one I have as well.
Anyone know where to get tines for these machines??
I have a broken one.

Sorry OP, I didn't get your info today but I will tomorrow.

Fins, this is the tag on my dad's tiller that I inherited shown in the pic.
Attachment 116568

Tiller tines are here.

Left tine -- https://www.cleancutter.com/cgi-bin/....asp?catid=514

Right tine -- https://www.cleancutter.com/cgi-bin/....asp?catid=513

I would call to confirm. I believe another member "Dave1953" purchased some a few years ago and he said they looked correct.

From the gearbox oil seal to the end of the shaft mine measures 19 7/8". Let me know if you need more info.

Attachment 116581Attachment 116582

Thanks so much awesome help ., its MUCh easier to build with a starting point for length , I have the splined male yoke but thats all Iv got for now