129 hydro control
 

I have a 129 with the controls as parts 16, 17, 18, 19, 20, & 21 below. Is there any repair procedures to replace parts 20 & 21? I haven't dis-assembled anything yet, so I don't know if there is any wear on part 18. I've tried looking in some of the other threads, but didn't have much luck.

Thanks,
Larry

You can buy part #20 new... Check with our sponsors, if they don't have them then your local Binder dealer can get you fixed up.

If my memory serves me correctly I think part #20 is a little spendy, about $6.00 I think.

It's been awhile since I messed with one but I think if you unbolt part #16 it will come out from underneath and easy enough you can see what you're dealing with. Unless there is a good gap between the "prongs" on part #16 I normally run the bandsaw between them... It seems like it makes it a little easier to snug it back up when you put it back together.

Thanks, Yosemite Sam. I'll check with my local cub dealer. I had looked at the cub parts listing at the upgrade parts, but didn't consider they still had the parts for the old style.
Larry