125 hydraulic lift install and rebuild driveline.
 

I have been looking for a NF hydraulic lift for some time. A few weeks ago I drove 10 hours round trip and bought a running working 125 with hydraulic lift. Finally got time to remove the lift from the donor tractor and installed on my 2 owner 125 and it’s working great. Also had to do the cork seal and I figured while I had it split I would replace the rear drive coupling, the flex disc, the drive shaft, the front drive hub, and fresh filter and fluids all around. Should be good to go for a bit.

Good job!! You should be good for another 40 years or so.
Now tell me about your rear tires. Are they an R14 type? What size and brand?

They are Carlisle Versa-Turf. Cross between Ag tire and turf tire. This set is standard 23x8.50x12 for the 125

https://www.carlislebrandtires.com/o...il/versa-turf/

Thank You. I like!

Looking good.

:IH Trusted Hand:

Those tires look great, nice job!

Cool, I have been looking for a lift for my 125 as well for lots of years.
You renewed my hope. And your machine looks pretty darn good also.

Ken

What's up on the 2 roll pins on the pump side?

There is only 1 roll pin. There are 2 set screws on opposite side that tighten on the shaft.

What ever you do, do not fill these tires with Rim Guard, as it tend to damage the Tire. Deere puts warning in their manual about it, and Deere dealers have ignored the warning. They are now finding out, the Rim Guard does something to the Radial Ply designed side walls causing, the tires to fail.