782 Duct Spacers
 

On the 782, there is a Top Duct Assembly, being 703-0180. This duct assembly is held in place by two studs coming off the exhaust manifold elbows, along with some machine screws on each side. Focusing on the two studs, there is a "spacer" that is installed on those studs, to prevent crushing of the duct work down. This duct work was added by IH and not Kohler. I have searched Kohler's and Cub Cadets parts sites, as well as looking into my paper archives, and can not find what I am looking for, those spacers.

I would like to know:
(A) The part number for those spacers
or
(B) the length of those spacers, so some could be fabricated.

:bigthink:

.875 long .532 OD x .360 ID, and 1/4" pipe nipple works well. ( I just checked)

Thanks George.

:beerchug: