Only Cub Cadets

Only Cub Cadets (https://www.onlycubcadets.net/forum/index.php)
-   IH Cub Cadet Tractors (GT) (https://www.onlycubcadets.net/forum/forumdisplay.php?f=9)
-   -   Original input shaft seal (https://www.onlycubcadets.net/forum/showthread.php?t=59360)

That_cub_dude1847 10-12-2021 06:15 PM

Original input shaft seal
 
Quote:

Originally Posted by Alvy (Post 320638)
You can view the service manual for the original on how to remove. 2 bolts on left side, one bolt on right side, remove clutch actuator shaft, and 2 bolts at flex coupler, drop out drive shaft and clutch as a unit. Drive out spiral pin at input shaft and remove coupler. Put a couple screws in the seal and pull out with vice grips. I would make sure you don't have a lot of play in the input and inspect input shaft for scoring. Both of which will make it leak. Here is a pic of clutch you will be removing. You can take out entire rear with 4 big 3/4 head bolts and disconnect brake linkage too but I think this can be done under tractor with rear in place just as easy.

Attachment 63699

Should I put any sealant around the seal?

darkminion_17 10-12-2021 06:52 PM

No. 10 characters


All times are GMT -4. The time now is 07:30 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.