782 Rear Lift
 

I've searched for two days and can't seem to find the answer so here goes , did they make a rear lift for the later serial # 782 Hydro ?? I have a wide frame lift here but it fits the manual lift cubs. Was hoping to make it work but not sure if it will. All the info I can find is for the lower serial # cubs. TIA Paul :American Flag 1:

How about a picture of your rear end....

Uncle Lewy.....Shame on you. That is VERY SUGGESTIVE!:biggrin2:

Cub Cadet 123

Pics
 

Heres the pic of my rear

If I recall, the lifts are the same, but the bolts to the frame are different. I have several of each lift (WF) and 82 series, but haven't seen them for years. Just sat them down once I got them and they are in my cub pile. I think the bolts to the 82 series were kind of like Frankenstein bolts. Someone else can chime in with pics or correct me if I am wrong.

Cub Cadet 123

Yes the bolts are different. PBJ makes those special bolts. you still will have to see if the lift bar off a quiet line will work though.

bolts
 

Thanks , I ordered the bolts from Jeff today. Pretty sure I need a straight lift arm and the front attaching hardware. But it should work. Does anyone have a pic of how the lift bar attaches up front at the lift cylinder ?? Can't seem to find any pics or info on it. Thanks

It uses a clevis pin that holds it on the rock shaft arm.

I have a Cat 0 lift for my 782D. Dunno if they're the same for the 782.

Can I join the conversation? Here is a photo of the lift mechanism on my IH 782 (Ser # 731511)

Where would the lift arm for a rear sleeve hitch or a three point hitch attach?

https://images41.fotki.com/v1397/pho...4919889-vi.jpg