Only Cub Cadets

Only Cub Cadets (https://www.onlycubcadets.net/forum/index.php)
-   IH Cub Cadet Tractors (GT) (https://www.onlycubcadets.net/forum/forumdisplay.php?f=9)
-   -   Driveshaft on a 123 (https://www.onlycubcadets.net/forum/showthread.php?t=55970)

jzidle 10-03-2019 02:28 PM

Driveshaft on a 123
 
What's the easiest method anyone has for removing/replacing a driveshaft on a 123? Thanks!

Billy-O 10-03-2019 08:26 PM

When I replaced the driveshaft on 125, I did what this other forum member does: https://www.onlycubcadets.net/forum/...6&postcount=19

It's a good way to clean the crud off outside of the pump while you're at it. Inspect the linkage and swash plate, too!

steelsmith 10-26-2019 11:23 PM

When I got my 123 it had been setting in a barn for over 10 years so I did as the post above said and pulled it in two and as long as I had it that far apart I took the back cover plate off, cleand out all the oil and gunk the was in the case, then I drilled and taped a drain hole in the buttom of the case. as long as I hade the back cover off and the drill and tap set out I drilled and taped a fill hole on the top of the case.
I also placed a small magnet insaid the case near the drain hole jest becouse I had one and the case was open.
I put it all back together and filled it up to the fill hole on the back cover plate , so now when/if I need to change Hyd oil in it I can do so with out pulling the back cover off.
Joe


All times are GMT -4. The time now is 05:22 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.