Question about a 582 Special
 

I have a international harvester 582 special and the rivets for the governor link on the carburetor are loose. Is it possible for the link to be removed and replaced? or will I have to get a new Carburetor for it?

Its a 16 hp Briggs & Stratton engine.

sorry for the double post

Please correct me about the linkage name if im wrong because on a diagram that looks like the exact carburetor my 582 has it as the governor linkage but on another place i looked it said its a carburetor linkage so sorry if this confuses people.

:Welcome2:

Got a pic?

Welcome to our Forum.....:Welcome2:

I don't that much about B & S Motors, so pictures would be most helpful...!!

:WWP:

Thank you for welcoming me to the site.

ill get a picture really soon. my uncle has the key to the barn where it is parked and he is at work.

There is two pictures i put as attachments to this post. one close to the rivet and one of the whole bar and surroundings.
This is the way I got it. I have no idea what the previous owner did to it.

I don't understand what you think the problem is...everything looks fine:confused2.gif"

The rivet is really loose causing the bar to not do it's job. for some reason when the tractor ran when I went up a hill the engine stalled out. Oh, I don't mean to bring up another question too, but i was wondering what does it mean when you put the tractor in gear and let off of the clutch the belt slips off of the tensioner?
To be honest though, I don't really know a lot about tractors that's why I'm really trying my best to explain what I think is wrong, Sorry.

If the linkage piece isn't binding and doesn't fall out...there's nothing wrong. It has to be somewhat 'loose' or it would bind up.

As far as your other problem, sounds like you might need a new drive belt.

Ok Thanks and I have tried replacing the drive belt but it still slips off.