Haban 401 54" Blade Springs
 

Does anyone have a source for the HA-12383 trip springs for the 54" Haban? I bought a blade with no springs and would rather find something similar to OEM, versus getting some generic springs to work.

I have done some research into this. I found that the Haban Springs 12383 had become NLA in 2004. With that in mind, I am going to venture to say, that chances of finding them are very slim. Thus, I am thinking that some aftermarket springs may be in order.

Thanks Roland. I believe Agri-Fab bought out Haban. Perhaps if I call them they would have an old drawing with spring coefficient, free length, diameter, etc so that I can find springs close to the original.

I talked with Charlie at CC Specialties, and he suggested since the Cub Cadet PO27 is about the same size but a stronger spring, just use two of them instead of the 4 Haban Springs. He has them in stock. Click on sponsor's tab above.

Thanks Roland. I talked with Rob Houtz and CC Used Parts, and he had none of the Haban springs. I also talked with Agri-Fab, and they do not support any Haban product lines other than some tillers. Lastly, I called Messicks, and they do not show any springs in stock at any dealer.

Just ran across this while looking for something else.

Use garage door springs cut and bend the ends they work fine.