Duals
 

So I got this FEL a couple of years ago. I'm finally, (I hope) getting ready to do something with it. Everything works except the tractor will jump out of gear in reverse and the clutch is shot I may just put the loader on a better tractor I have. Anyhow, while at work today I was down in the tool room and the guys down there will make up a set of plates so I can put duals on it. I need advice as to how wide to make them, or if anyone has already made drawings or dimensioned the spacer set up for it, that would be great.
Thanks

You need to make them long enough to have about 1 1/2" between the tires, just set another tire next to it and measure.