Only Cub Cadets

Only Cub Cadets (https://www.onlycubcadets.net/forum/index.php)
-   IH Cub Cadet Tractors (GT) (https://www.onlycubcadets.net/forum/forumdisplay.php?f=9)
-   -   Gear Drive Driveshafts? (https://www.onlycubcadets.net/forum/showthread.php?t=44696)

WishIhada168 06-21-2016 09:32 AM
Gear Drive Driveshafts?
 
Does anyone have the hole spacing for a shaft with a creeper? Or does anyone know where I can get a shaft made with a creeper hole but without the spring hole? I'm going to use a set of clamps instead of the spiral roll pin.

Sam Mac 06-21-2016 09:59 AM
Contact member JeffinPA

http://www.onlycubcadets.net/forum/s...ad.php?t=20875

Mike McKown 06-21-2016 10:29 AM
Quote:
Originally Posted by WishIhada168 (Post 380351)
Does anyone have the hole spacing for a shaft with a creeper?
Some of the narrow frame and wide frame tractors had a groove around the standard length driveshaft to indicate where it should be cut for a Creeper.

vr4Legacy 06-21-2016 01:00 PM
Quote:
Originally Posted by Sam Mac (Post 380361)
+1 for Jeff in PA

Easy to work with and quality work!

Jeff in Pa 06-21-2016 09:37 PM
Quote:
Originally Posted by WishIhada168 (Post 380351)
Does anyone have the hole spacing for a shaft with a creeper? Or does anyone know where I can get a shaft made with a creeper hole but without the spring hole? I'm going to use a set of clamps instead of the spiral roll pin.
Let me know what model you have and which hole you want skipped. ( a creeper driveshaft will only use holes 1-4 )
http://img.photobucket.com/albums/v7...b.jpg~original

Jeff

WishIhada168 06-21-2016 11:28 PM
I'm thinking hole #3


All times are GMT -4. The time now is 12:31 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.