Cub "O" keeps blowing coils
 

I found an "O", runs great, just got done pulling tree limbs around with it. It died and has no spark, but this is the 2nd coil it's been through. Keep in mind, it was redone approx 10 years ago and then sat 5 years and the P.O got it to run not too long before I bought it. Any suggestions?

I will check later on this morning, but I am using genuine Koehler coils

I measured 12 volts about 11.8 at the battery not running

*between 11.8 and 12*

Check it running.... :RollEyes2:

My problem is my coil blew lol, can't run it,

Oh and stupid question, but how can you tell if a coil is totally done? I'm new to electrical

Possibly the coil is not bad and it is another component in the circuit causing a no spark condition. :bigthink:

Could be too much power out of the regulator.

That would be better if it wasn't the coil