Only Cub Cadets - Static timing question.

Only Cub Cadets (https://www.onlycubcadets.net/forum/index.php)

- IH Cub Cadet Tractors (GT) (https://www.onlycubcadets.net/forum/forumdisplay.php?f=9)

- - Static timing question. (https://www.onlycubcadets.net/forum/showthread.php?t=39535)

coinman66

06-19-2015 05:12 PM

Static timing question.

Do you start procedure with S in sight hole during a static timing test? And then followed by what?

timbo2

06-19-2015 05:40 PM

Check this out from the tech. section if you haven't-

http://www.onlycubcadets.net/forum/s...ead.php?t=4405

coinman66

06-19-2015 06:05 PM

Quote:

Originally Posted by timbo2 (Post 333959)

Check this out from the tech. section if you haven't-

http://www.onlycubcadets.net/forum/s...ead.php?t=4405

Yah I've been reading this, but it doesn't really say to start procedure with S in sight hole?

austin8214

06-19-2015 06:15 PM

Quote:

Originally Posted by coinman66 (Post 333967)

Yah I've been reading this, but it doesn't really say to start procedure with S in sight hole?

Roll it over by hand in the normal direction of rotation. When the meter goes to infinity look for the S. If it is past the hole tighten up the gap. If it has not gotten to the hole yet widen the gap.

jimbob200521

06-19-2015 06:16 PM

Try this one:

http://www.onlycubcadets.net/forum/s...ad.php?t=33461

timbo2

06-19-2015 06:17 PM

if the points start to break with the S in the sight whole then you are done. I would back it up abit and see what your VOM does as the S appears in the whole. then adjust from there.

coinman66

06-19-2015 06:58 PM

Quote:

Originally Posted by timbo2 (Post 333971)

if the points start to break with the S in the sight whole then you are done. I would back it up abit and see what your VOM does as the S appears in the whole. then adjust from there.

Ok. Thank u much!

All times are GMT -4. The time now is 01:59 PM.